Stop LFX from launching when opening the SDS200 software (for example in demo installations)

Stop LFX from launching when opening the SDS200 software (for example in demo installations)

Go to the folder C:\Program Files (x86)\Schiller\Application\SDS200\Settings\FactorySettings and find the SFF_DeviceSettings file.



Open the SFF_DeviceSettings file with Notepad and locate at the end of the file the LFX settings section. Change the value for <StationDeviceAutoStart> from 1 to 0 and save the changes made to the SFF_DeviceSettings file.



When the SDS200 software is launched it will not automatically open LFX. 

    • Related Articles

    • LFX Database Backup

      Attached is the LFX Database back-up

    • Backup LFX Database using HeidiSQL

      When you have installed MySQL during the LFX installation, there will be a “HeidiSQL” shortcut on your desktop. Start it and enter the user: “root”And password: “sGanshorn#LFX” Port 3307 (for LFX versions with 1.71 or higher), port 3306 for older ...

    • SDS-200 Excellence Archive

      If you have a customer that the hard drive is close to 70% of usage and we would like to archive the studies older than one year. Log in to the SDS-200 software and configure the Archiving settings and select apply. Once applied , press ok. Instead ...

    • Updating LFX 1.8 to LFX 1.10.1

      1. Make a backup of the Ganshorn LFX folder under program data + a backup of the database. 2. Update the LFX version to 1.9 first with msi upate file (for version 1.9). 3. Enter LFX and the database settings - do the database update. 4. Close LFX and ...

    • Starting tremoFlo software in GDT mode

      The tremoFlo SW GDT license requires that the tremoFlo SW be run in GDT mode, meaning it is only accessible through LFX by performing a calibration or test. However, it is possible to access the tremoFlo SW in standalone mode (without going through ...